I knew I wanted to hang this up on the end of a shelving unit to take up the smallest area (and an area that wasn’t being used) hanging it like this also meant I could use the shelves to hold the larger Profoto batteries when they were charging. If the battery pack is charging, there should be one green status light. It takes 9 hours to fully charge the battery from 0 to 100. To make the best use of the space on the board I ordered a mix of short IEC C7 cables (0.5m) some with straight ends and some with right angles – this was to be able to get the chargers closer to the power block.Īfter those had arrived it was a case of laying everything flat and figuring out the best way of doing it. Charge the battery pack using the included charging cable. I also ordered an 8-gang extension with USB ports and an on/off switch (this enables you to turn the whole board off at the board rather than the mains, way more convenient) I knew I would have to use longer cable ties, after some measuring I bought 300mm ties to make sure they’d go around the wider chargers. The base of it needed to be big and robust, weight wasn’t an issue, so I bought a Vonhaus Steel Pegboard on Amazon, it came as a set of three, so I shipped the other two off to friends rather than chuck them away. I had seen various pegboard setups in the past and have tried out a mini version before using a guitar pedalboard, but this is the first time I’m gone big with all the chargers. Ensure that the camera & Connections are powered off. Now, I don’t want to say this is the best solution as I’m sure someone else has made something neater (and if you have any ideas, please comment below) but for me, this setup works well and doesn’t cost much. I’ve tried various things over the years, I’ve tried to hide them in drawers, Velcro ing them to the wall or under a desk, it has always ended up in the same mess. A mess of wires that always seem to get tangled and it always ends up looking like Medusa on a bad hair day, so I decided to create my own custom charger board. Remove the battery by gently pulling it out of its compartment. The battery cover will pop off, revealing the battery inside. Insert a small paperclip or similar object into the hole and press firmly. SDKC 1080P USB Adapter Spy Charger Camera Invisible Hidden Wall Charger With Motion Detection Smart Video US/EU Plug. I was, as I’m sure a lot of you are, utterly sick of endless chargers and cables. Locate the small hole on the back of the doorbell next to the mounting bracket.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |